MultiPlus 5000 Watt 120

New product

Inverter/charger Victron Multiplus
 12V-220A carga,24V-120A carga,48V-70A, 230VAC 5000 Watt

More details

2 073,50 € tax incl.

More info

MultiPlus 800VA - 5kVA


Multi-functional
The MultiPlus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure. Models range from 800VA to 5000VA per module.

Unique PowerAssist feature
The MultiPlus will prevent overload of a limited AC source. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.

Uninterrupted AC power (UPS function)
In the event of a grid failure or shore or generator power being disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.

Virtually unlimited power thanks to parallel operation
Up to 6 Multi's can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. Please check our datasheets to see which models have paralleling, three-phase and split phase capabilities.
 

Four stage adaptive charger and dual bank battery charging
The main output provides a powerful charge to the battery system by means of advanced ‘adaptive charge’
software. The software fine-tunes the three stage automatic process to suit the condition of the battery, and
adds a fourth stage for long periods of float charging. The adaptive charge process is described in more detail
on the Phoenix Charger datasheet and on our website, under Technical Information. In addition to this, the
MultiPlus will charge a second battery using an independent trickle charge output intended for a main engine
or generator starter battery (trickle charge output available on 12V and 24V models only)

System configuring has never been easier
After installation, the MultiPlus is ready to go.
If settings have to be changed, this can be done in a matter of minutes with a new DIP switch setting procedure.
Even parallel and 3-phase operation can be programmed with DIP switches: no computer needed!
Alternatively, VE.Net can be used instead of the DIP switches.
And sophisticated software (VE.Bus Quick Configure and VE.Bus System Configurator) is available to configure
several new, advanced, features.

 

 
 

 

 

 

Download